We are committed to entering the domestic and foreign markets at the same time in the Quick Deck Slab Formwork, Mold Concrete Steel Concrete forms Ties, Flat Tie Aluminum Formwork System field, and regards product quality as the lifeblood of the company' s survival. Based on rich experience, with fully automated production technology and packaging equipment, coupled with the company's safety and quality monitoring, to ensure that all products pass strict quality verification and verification. We hope that employees will realize their own value in creating corporate value, and realize the perfect combination and unification of corporate value and employee value. Our company's business has achieved rapid and fruitful development, and has been more widely recognized in the market.

Level measurement

1) Before assembling the formwork, measure the elevation level of the concrete floor at the assembly position.

2) The level measurement is based on T.B.M (temporary level base point).

3) The measurement records shall be archived and kept by the designated supervisor.

4) When measuring, drawing positive (+) or negative (-) on the floor to mark the measurement result is an effective method.

5) Where the elevation along the wall line exceeds the design elevation by 10mm, it should be turned to no more than 10mm. Where the wall line is lower than the reference point, plywood or wood should be used to fill the template to the required level. The corners and low places in the walls must be fully filled.

6) After the concrete is poured, the top of the starting board (K board) outside the flat mold needs to be measured horizontally. The levelness of the starting board (K board) on the outside of the flat mold will cause the structure to deviate from the center line, otherwise the template cannot maintain its sag.

7) In order to facilitate adjustment of the starting board (K board) outside the flat mold after pouring, a 26mm long hole is opened.

8) Same as the level measurement of concrete surface, the measurement records of the starting board (K board) on the periphery of the flat form shall also be archived by the designated supervisor. At the same time, deviation detection should be performed and recorded and archived

Pay off

1). The error of the wall template line should be controlled within 1mm, and a control line should be placed in parallel in the same direction 150mm from the outside of the template line.

2) The stake-out line should pass through the opening, external angle, etc. at least 150mm to facilitate the control of the correct position of the template before pouring.

3) The reference point and the stakeout point are very important, which directly affect the verticality of the wall, and it is strictly forbidden to move or damage them.

We are advancing courageously along the road of 'groupization, industrialization, specialization, and internationalization' and continue to contribute to the Adjustable Reuseable ABS Plastic Formwork Plastic Moulds industry all over the world. This technological innovation has solved the situation of my country's pharmaceutical industry for many years and established a new international order centered on my country! Your satisfaction is our pursuit. Advanced technology, reliable quality, thoughtful service is our permanent commitment.

Hot Tags: column construction formwork mold, China, suppliers, manufacturers, cheap, quotation, low price, in stock, Mold Concrete Steel Concrete forms Ties, Aluminum Formwork Accessories, Aluminum Formwork, Villa Aluminum Formwork System, Aluminum Formwork System, Formwork Accessory for Casting Construction